Marine High Protective Coatings Top Coats
Sea Guard Epoxy Enamel
This is a two pack high performance top coat Based on Epoxy resin and stable pigments Chemical resistance and Saline water resistance of Epoxy Resin makes this coating ideal for iron and steel surfaces as top coat Its excellent resistance to saline water properties are suitable for marine exposure.
AREA OF APPLICATION:
It is used on all iron & steel, concrete and wooden surfaces of all river or sea-going vessels, pontoons, sea-shore structures etc.
SHADE:
White, Grey , Light Blue , Turquoise, Black. Other color will be on request.
TECHNICAL INFORMATION:
Viscosity
100 - 110 seconds/BSB4/30ºC
Gloss
High Gloss
Mixing Ratio
Base : C/A = 2:1 by volume
Pot Life (After mixing)
6 hrs approx.
Thinner
Roxy Epoxy Thinner
Thinning ratio
8-10 %
Coverage
475-500 sft / 4 liters. On non absorbent surface
Recommended DFT
40- 45 microns / coat
Flash point
Below 70º F
DRYING TIME:
Surface dry:1 - 1.5 hrs
Hard dry:10 – 12 hrs
Recoating time:After 12 hrs
Full Cure:7 days
Shelf Life
One year in sealed container when kept in cool and dry place.
Pack Size
4 Ltr, 20 Ltr
SURFACE PREPARATION
The surface must be properly cleaned and free from rust, old paints, grease, wax, salt deposit or other contaminants. Repair surface defects before painting.
APPLICATION METHOD
Always stir paint properly before use. Mix paint with Curing Agent (Hardener) at 2:1 ratio by volume. Apply by brush or roller after thinning 8-10% by vol. with Roxy Epoxy Thinner. Mixed paint must be used off with in 6 hrs approximately. Apply 2 coats of this finish paint Check proper drying before next coat. This paint can be applied by spray after proper thinning.
The information given herein is to the best of our knowledge accurate and is believed to be reliable. We do not take any responsibility since the conditions of use are beyond of our control. For further information please contact our sales center nearest to you.
